|
Post by roughau on Feb 13, 2018 11:14:55 GMT 12
Gidday Rob. Do you know the above Pulley diameter ratios. Is there a previous thread on this subject. ?.
I have a 16HP Motor and the above HP500 and KAC1.
Maybe Boaraxa may remember what Pulley ratio he had when he was running his 5 in. Dredge a few years back.
Can anyone help me with this Please. ?.
CHEERS. RoughAU.
|
|
|
Post by RKC on Feb 15, 2018 9:10:07 GMT 12
|
|
|
Post by lbd on Feb 19, 2018 11:39:39 GMT 12
Can anyone help me with this Please. ?. CHEERS. RoughAU. I have had two std Keene set up with a GAST 263... but then adjusted it slower First set up the relief for the correct air pressure for the regulator to work fine. Decide if you will need air for one or two people. Then with one or two people working and drawing air, watch and listen for the relief popping off.. An occasional pop off say every five to seconds ten is good, however if there is constant air bleeding of from the relief valve at maximum air draw, you can then slow the compressor down. On the other hand, if you cannot sense the bleed of valve popping off and the pressure gauge is dropping, you may need to increase the speed of the compressor.
|
|
|
Post by roughau on Feb 20, 2018 10:53:02 GMT 12
Lbd and Rob. Many thanks for your info on the Compressors. It is great to have the Forum here to help with questions. Thanks again.
CHEERS JET>.
|
|